↓ Advertise on Defender2 ↓

Home > Puma (Tdci) > Puma Engine Issues
Post Reply  Down to end
Page 1 of 1
Print this entire topic · 
nickhodgson



Member Since: 08 Dec 2009
Location: Zambia
Posts: 174

 
Puma Engine Issues
Hi

I have a 2011 puma with 2.4tdci. 67k kms.

I have two issues with the engine as follows.

When accelerating after a period of low power demand I get a sort of squeal noise, like a slipping belt. It stops if I reduce throttle a bit. Leaking manifold or turbo actuator?

The second is 4 times so far no throttle response. The engine just has no power. It does not cut out and restarting it a few times restores power.

A diagnostic check reveals brake switch fault, and injector leak. The injector leak was not specific to any injector. There is not fuel or residue under the engine cover or elsewhere. The checks also revealed that at the time the accelerator pedal was sending full signal.

The fuel filter and air filter where changed 2500kms ago. I used standyne fuel filter and allmakes air filter. 1995 300tdi Defender 90 P/UP
2011 Puma Defender 130 D/C
2000 300tdi Defender 110 P/UP
2015 Discovery 4 SDV6 HSE
Post #291830 20th Dec 2013 6:00am
View user's profile Send private message View poster's gallery Reply with quote
blackwolf



Member Since: 03 Nov 2009
Location: South West England
Posts: 17372

United Kingdom 2007 Defender 110 Puma 2.4 DCPU Stornoway Grey
The squealing noise is most probably a leak from the pipe from turbo to intercooler. Check for abrasion damage from the steering components (a common problem with the 2.4).
Post #291852 20th Dec 2013 8:47am
View user's profile Send private message View poster's gallery Reply with quote
Lorryman100



Member Since: 01 Oct 2010
Location: Here
Posts: 2686

Have a read of this post I did on another forum, (saves me writing it all out again. Embarassed )

http://www.aulro.com/afvb/90-110-130-defen...turbo.html

It could very well be a leaking boost hose but does the squeeling coincide with boost demand and what psi does the squeeling start at??

HTH. Thumbs Up
Post #291881 20th Dec 2013 9:37am
View user's profile Send private message View poster's gallery Send e-mail Reply with quote
nickhodgson



Member Since: 08 Dec 2009
Location: Zambia
Posts: 174

 
The squeal noise is when I want to accelerate. So I guess when I want an increase in boost. Don't have boost gauge so don't know what PSI. At full speed there is no noise. 1995 300tdi Defender 90 P/UP
2011 Puma Defender 130 D/C
2000 300tdi Defender 110 P/UP
2015 Discovery 4 SDV6 HSE
Post #292038 20th Dec 2013 8:08pm
View user's profile Send private message View poster's gallery Reply with quote
Lorryman100



Member Since: 01 Oct 2010
Location: Here
Posts: 2686

Most diagnostic tools allow the monitoring of live data which will include the boost psi. Thumbs Up
Post #292206 21st Dec 2013 3:49pm
View user's profile Send private message View poster's gallery Send e-mail Reply with quote
Likeomg



Member Since: 29 Jun 2012
Location: Lake District / Newcastle
Posts: 2640

2010 Defender 90 Puma 2.4 HT Stornoway Grey
while on engine issues, anyone got any idea what could cause this?

its a 2010 2.4, 48k miles when like overtaking in 5th / 6th gear you put your foot down and the car will start to accelerate then 3-4 seconds after the engine looses all power, then picks up again... goes on and off like this
Post #292207 21st Dec 2013 3:55pm
View user's profile Send private message View poster's gallery Reply with quote
Lorryman100



Member Since: 01 Oct 2010
Location: Here
Posts: 2686

What is the engine revs and vehicle speed when this happens? Has the speed limiter been removed through a remap?
Post #292210 21st Dec 2013 3:58pm
View user's profile Send private message View poster's gallery Send e-mail Reply with quote
Likeomg



Member Since: 29 Jun 2012
Location: Lake District / Newcastle
Posts: 2640

2010 Defender 90 Puma 2.4 HT Stornoway Grey
still limited to 82 and id say approx 2000 - 3500?

not to sure the cars having its 48k serv and a few other bits and bobs, have mentioned it to dealer but they never told me they found out and are yet to give it a test drive
Post #292213 21st Dec 2013 4:04pm
View user's profile Send private message View poster's gallery Reply with quote
K9F



Member Since: 12 Nov 2009
Location: Bournemouth
Posts: 9610

United Kingdom 2008 Defender 90 Puma 2.4 XS CSW Stornoway Grey
Sounds to me the exact symptoms of you hitting the limiter and/or the engine is 'overboosting' another symptom I had with my old remap, ultimately you will need a diagnostic run/fault reader to see exactly what's going on. If you go through life with your head in the sand....all people will see is an ar5e!!

Treat every day as if it is your last....one day you will be right!!
Post #292217 21st Dec 2013 4:13pm
View user's profile Send private message View poster's gallery Reply with quote
CRJ



Member Since: 12 Mar 2011
Location: Sealand - Denmark
Posts: 253

Denmark 1991 Defender 90 200 Tdi ST Alpine White
I have experienced similar - it all came down to gasket between turbo and manifold.
Regards
CRJ 88 Ser. 3 1980 -sold
Puma 130 - 08- sold
90 200tdi 1991 - sold
88 Ser. 3 1977 200 TDI
110 CC 2003
Post #296046 5th Jan 2014 5:00pm
View user's profile Send private message View poster's gallery Reply with quote
vodonos



Member Since: 13 Jan 2013
Location: CERKNICA LAKE
Posts: 29

Slovenia 2012 Defender 110 Puma 2.2 SW Sumatra Black
I have similar symptom with water in fuel filter
Best regards BOŠTJAN
SLOVENIA
Cerknica lake
90 td5 2000
110 2,2 2012
Post #296100 5th Jan 2014 7:23pm
View user's profile Send private message View poster's gallery Reply with quote
nickhodgson



Member Since: 08 Dec 2009
Location: Zambia
Posts: 174

 
I may have solved this problem....

The engine lost power again. I stopped with the engine running and opened the bonnet. I was looking at the electrical connectors and checking they were fitted correctly and secure. When I touched the one on the front of the fuel rail the engine hiccuped. When I touched it again it hiccuped again. I switched the engine off and unplugged the connector and it looked ok but was under tension from the loom. I adjusted the loom slightly so the connector was not under tension and the problem has yet to re-occur. I also slightly adjusted one of the female connectors in the plug as it did not look like it was making as good a connection as the other connectors.

Is it likely that this connector being loose could give me the symptoms previously described? 1995 300tdi Defender 90 P/UP
2011 Puma Defender 130 D/C
2000 300tdi Defender 110 P/UP
2015 Discovery 4 SDV6 HSE
Post #296784 8th Jan 2014 6:23am
View user's profile Send private message View poster's gallery Post Reply
Post Reply  Back to top
Page 1 of 1
All times are GMT

Jump to  
Previous Topic | Next Topic >
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



Site Copyright © 2006-2024 Futuranet Ltd & Martin Lewis
DEFENDER2.NET RSS Feed - All Forums