| Author |
Message |
 Puma 2.4 Not Cranking or Starting |
konamac
 15th Jan 2020 6:12am
|
Forum: Puma (Tdci) · Replies: 8 · Views: 7514 · Subject: Puma 2.4 Not Cranking or Starting |
UPDATE: SOLVED
Been meaning to update this for a while, but was on leave.
Turned out the starter motor had failed, did some tests, most simply a bump start when I had some extra hands and she s ... |
| Puma 2.4 Not Cranking or Starting |
konamac
19th Nov 2019 6:00am
|
Forum: Puma (Tdci) · Replies: 8 · Views: 7514 · Subject: Puma 2.4 Not Cranking or Starting |
| Thank, will test that a bit later when I get the chance. I think I also need to try turn the starter over direct from the battery too, just to eliminate that completely. Time for the jump lead tests! |
| Puma 2.4 Not Cranking or Starting |
konamac
18th Nov 2019 2:01pm
|
Forum: Puma (Tdci) · Replies: 8 · Views: 7514 · Subject: Puma 2.4 Not Cranking or Starting |
Update:
I have tried starting with the instrument pack removed and the terminals no's 3 & 4 bridged as described in previous posts on similar problems elsewhere but nothing happens. Same resul ... |
| Puma 2.4 Not Cranking or Starting |
konamac
18th Nov 2019 1:58pm
|
Forum: Puma (Tdci) · Replies: 8 · Views: 7514 · Subject: Puma 2.4 Not Cranking or Starting |
Do your AC blower and radio work? If not, then it is most likely the ignition switch that needs replacing.
Also make sure that the battery clamps are REALLY secured to the posts as sometimes they o ... |
| Puma 2.4 Not Cranking or Starting |
konamac
18th Nov 2019 1:53pm
|
Forum: Puma (Tdci) · Replies: 8 · Views: 7514 · Subject: Puma 2.4 Not Cranking or Starting |
| Hi Blackwolf, thanks for the tip. I have checked the relay and even swapped it out for another similar one to test, no difference when cranking. The relay did slip off quite easily, so for good measu ... |
| Puma 2.4 Not Cranking or Starting |
konamac
16th Nov 2019 8:40am
|
Forum: Puma (Tdci) · Replies: 8 · Views: 7514 · Subject: Puma 2.4 Not Cranking or Starting |
Hi
My problems manifest much as johnnyd's that were sorted out by Martin some time ago with a few differences. My 2008 2.4 Puma used to have an intermittent "cranking failure" to start, ... |
| doors - holding open |
konamac
4th Nov 2013 12:30pm
|
Forum: Puma (Tdci) · Replies: 17 · Views: 7633 · Subject: doors - holding open |
| You can tighten up the torsion bar all you like but I think there is is another reason the doors swing closed so easily. Inside the sliding channel for the check stay and beyond the torsion bar is a g ... |
| HCPU into Station Wagon, missing wiring plugs? |
konamac
8th Sep 2013 6:02am
|
Forum: Puma (Tdci) · Replies: 2 · Views: 2739 · Subject: HCPU into Station Wagon, missing wiring plugs? |
Thanks Paul for the fantastically detailed reply  , I will check this in the workshop later this morning. It would probably also make sense to check the fuse box to see if this side of the circu ... |
| HCPU into Station Wagon, missing wiring plugs? |
konamac
7th Sep 2013 9:19pm
|
Forum: Puma (Tdci) · Replies: 2 · Views: 2739 · Subject: HCPU into Station Wagon, missing wiring plugs? |
Hi
Busy converting my 2008 puma HiCap (rhd) into a station wagon. From my understanding Land Rover uses a "One size fits all" Main Wiring Harness or loom. Specifically I'm looking for the ... |
| |
