DEFENDER2.NET - View topic - Hazard switch problem

↓ Advertise on Defender2 ↓

Home · FAQ · New Posts · My Posts · PMs · Search · Members · Map · Calendar · Profile · Donate · Register · Log In

Home > Maintenance & Modifications > Hazard switch problem

Page 1 of 1

Print this entire topic ·

gavinpm

Member Since: 19 Oct 2012
Location: Wiltshire
Posts: 117

Hazard switch problem

My hazard switch will switch between the on and off position normally. However in the On position the lights do not flash, but when I push the switch in a fraction they operate normally and stop again when I release.

New switch required ?

Thanks
Gavin

14th Mar 2015 10:22am

Terryt

Member Since: 28 Jun 2012
Location: Lerryn. Cornwall.
Posts: 750

Drop the switch out mate had that issue the block at the back had worked lose.
Terry

14th Mar 2015 10:53am

Go Beyond

Member Since: 30 Jan 2012
Location: Headcorn, Kent
Posts: 6678

They do jamb in the housing as well, especially if the centre panel has been painted, a little Vaseline around the edge will help

14th Mar 2015 11:48am

gavinpm

Member Since: 19 Oct 2012
Location: Wiltshire
Posts: 117

Thanks gents.

Terry what exactly do you mean by 'drop the switch out' - I was under the impression that I would have to remove the dash. If there is an alternative to removing the dash I would be happy with that.

Thanks
Gavin

14th Mar 2015 12:20pm

Page 1 of 1

All times are GMT

Jump to

< Previous Topic | Next Topic >

Posting Rules

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum