↓ Advertise on Defender2 ↓

Home > Puma (Tdci) > engine n transfer box mounts
Post Reply  Down to end
Page 1 of 1
Print this entire topic · 
Caterham



Member Since: 06 Nov 2008
Location: Birmingham
Posts: 6298
England 2011 Defender 110 Puma 2.4 XS CSW Stornoway Grey
engine n transfer box mounts
Would someone be so kind as to explain how easy it is to replace them (or not as the case may be).

Thumbs Up
Post #506521 20th Feb 2016 9:30pm
View user's profile Send private message View poster's gallery Reply with quote
Caterham



Member Since: 06 Nov 2008
Location: Birmingham
Posts: 6298
England 2011 Defender 110 Puma 2.4 XS CSW Stornoway Grey
Bump!
Post #506637 21st Feb 2016 11:39am
View user's profile Send private message View poster's gallery Reply with quote
Retroanaconda



Member Since: 04 Jan 2012
Location: Scotland
Posts: 2645
Scotland 
Not done any on a Tdci but generally you undo them, lift raise the engine/transmission (using a crane for the former or a jack for the latter), replace, lower and re-fix.

Sometimes it can be a bit of a faff as depending on what is connected to the engine (e.g. cooling hoses/fuel pipes etc.) there is only so far you can lift the block. Same goes for propshafts on the transfer box. If you come across problems then the solution is to remove the actual brackets from the block/box/chassis as appropriate which will allow you to swap the mount over outwith the vehicle and then refit.

Do NOT use aftermarket rubbish.
Post #506701 21st Feb 2016 3:33pm
View user's profile Send private message View poster's gallery Reply with quote
Caterham



Member Since: 06 Nov 2008
Location: Birmingham
Posts: 6298
England 2011 Defender 110 Puma 2.4 XS CSW Stornoway Grey
thank you Retroanaconda,

I was thinking the gbox looked easy enough (using a jack) but think it's best to get them all done by someone who knows what they're doing.

any thoughts on how may the gbox should move under normal condition (well road use Mr. Green ) the earth cable in the photo is normally a good 1cm away from the gbox mount heat shield but as you can see it's regularly rubbing on it?



Click image to enlarge
Post #507880 25th Feb 2016 7:11am
View user's profile Send private message View poster's gallery Reply with quote
Caterham



Member Since: 06 Nov 2008
Location: Birmingham
Posts: 6298
England 2011 Defender 110 Puma 2.4 XS CSW Stornoway Grey

Click image to enlarge

just found this from sometime ago. hadn't noticed at the time but the mount appears to be well off centre - is it normal?

thanks.
Post #507922 25th Feb 2016 9:42am
View user's profile Send private message View poster's gallery Post Reply
Post Reply  Back to top
Page 1 of 1
All times are GMT

Jump to  
<  Previous Topic | Next Topic >
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



Site Copyright © 2006-2024 Futuranet Ltd & Martin Lewis
DEFENDER2.NET RSS Feed - All Forums