↓ Advertise on Defender2 ↓

Home > Puma (Tdci) > Engine cutting out on motorway
Post Reply  Down to end
Page 1 of 1
Print this entire topic · 
Mollymole13



Member Since: 15 Feb 2022
Location: Essex
Posts: 2
United Kingdom 
Engine cutting out on motorway
Hi all,

I am having trouble whilst on the motorway I would drive for 5 to 10 mins fine (sometimes longer) then the engine cuts out and goes into a 'limp mode' where I have no acceleration BUT still driveable at 50

I pull over turn the engine off wait a while and then can go again. But the same thing will happen.

Any advice would be great.
Post #942659 15th Feb 2022 11:12pm
View user's profile Send private message View poster's gallery Reply with quote
Mollymole13



Member Since: 15 Feb 2022
Location: Essex
Posts: 2
United Kingdom 
2007 Puma 2.4 for reference
Post #942660 15th Feb 2022 11:12pm
View user's profile Send private message View poster's gallery Reply with quote
Dinnu



Member Since: 24 Dec 2019
Location: Lija
Posts: 3414
Malta 2012 Defender 90 Puma 2.2 CSW Santorini Black
Check that it is really not overheating... if that is ok, check the cylinder head temperature sensor.
I would connect to obd and check temperature through that.
The puma will reduce power to protect itself if it reads high cht. 1988 90 Hard Top, 19J Diesel Turbo, Shire Blue - Restoration ongoing
2012 90 CSW, 2.2TDCI, Santorini Black
Post #942664 16th Feb 2022 5:30am
View user's profile Send private message View poster's gallery Reply with quote
HardCharger



Member Since: 03 Mar 2013
Location: Manila
Posts: 734
Philippines 2011 Defender 110 Puma 2.4 SW Stornoway Grey
What does your temperature gauge read?
Post #942665 16th Feb 2022 5:33am
View user's profile Send private message View poster's gallery Reply with quote
MartinK



Member Since: 02 Mar 2011
Location: Silverdale (Lancashire/Cumbria Border)
Posts: 2665
United Kingdom 2011 Defender 110 Puma 2.4 USW Orkney Grey
I had something similar.

Initially cleaned MAF and MAP, but it didn;t completely clear the problem.

Then VCV

Which again changed the issues a bit but not completely.

After a LOT of head scratching I again changed the VCV, when I took the one out it was different!

All here https://www.defender2.net/forum/topic80592.html

I think it was the VCV, but I still have an underlying issue in that it occasionally stalls a few seconds after starting (which I think is a separate issue with the Throttle Position Sensor).

Good luck!!! Defender "Puma" 2.4 110 County Utility (possibly the last of the 2.4's)
Post #943036 19th Feb 2022 12:27pm
View user's profile Send private message View poster's gallery Post Reply
Post Reply  Back to top
Page 1 of 1
All times are GMT

Jump to  
<  Previous Topic | Next Topic >
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



Site Copyright © 2006-2024 Futuranet Ltd & Martin Lewis
DEFENDER2.NET RSS Feed - All Forums