DEFENDER2.NET - View topic - Loss of power (throttle non responsive) when going up gears

↓ Advertise on Defender2 ↓

Home · FAQ · New Posts · My Posts · PMs · Search · Members · Map · Calendar · Profile · Donate · Register · Log In

Home > Puma (Tdci) > Loss of power (throttle non responsive) when going up gears

Page 1 of 1

Print this entire topic ·

petercassidy

Member Since: 19 Nov 2019
Location: Eastbourne
Posts: 24

2007 Defender 110 Puma 2.4 XS CSW Bonatti Grey

Loss of power (throttle non responsive) when going up gears

I know this a frequent question....

Done a lot of reading on this and wanted to start with easy stuff to fault find.....so

I've just disconnect the clutch switch and shorted out the loom plug as a bypass (I have 2007 2.4 tdci puma).

The effect it had was to limit the top rev to 3000 rpm when pressing the throttle out out of gear, is this excepted?

If I reconnect it again the result is a lumpy throttle response, sometimes pumping the clutch a few times alters this (inconsistent results though).

Leaving the plug off altogether "without shorting it" on the loom side takes the 3000 rpm limit off and seems less lumpy.

Thoughts on this would be appreciated greatly.

19th Sep 2021 1:30pm

petercassidy

Member Since: 19 Nov 2019
Location: Eastbourne
Posts: 24

I haven't test driven it with the clutch switch disconnected and un-bridged.

Is it safe to do so?

19th Sep 2021 2:51pm

Page 1 of 1

All times are GMT

Jump to

< Previous Topic | Next Topic >

Posting Rules

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum