DEFENDER2.NET - View topic - Defender 110 2.2 2013 Gearbox

↓ Advertise on Defender2 ↓

Home · FAQ · New Posts · My Posts · PMs · Search · Members · Map · Calendar · Profile · Donate · Register · Log In

Home > Puma (Tdci) > Defender 110 2.2 2013 Gearbox

Page 1 of 1

Print this entire topic ·

audi1boy

Member Since: 11 Dec 2020
Location: Somerset
Posts: 24

2008 Defender 130 Puma 2.4 HCPU Barolo Black

Defender 110 2.2 2013 Gearbox

Afternoon all,

Have a 2013 110 Double cab Defender.

It had a new clutch about 6 months ago and with it a new clutch release bearing.

Then a few weeks ago i noticed that there was a worn bearing noise when you lifted/engaged the clutch in neutral. I pulled the gearbox and replaced the clutch release bearing again. But it has come back worse than ever.

When the vehicle is cold its ok but when its up to temp its quite loud when you engage the clutch/lift the pedal.

I have tried the stop the engine trick to see if its the springs on the clutch but its fine.

Will it be the input shaft bearing on the gearbox? Will it be worth getting the transfer box remanufactured at the same time if the bearing has gone?

TIA

11th Dec 2020 4:45pm

JOW240725

Member Since: 04 May 2015
Location: Suffolk
Posts: 7906

2012 Defender 110 Puma 2.2 XS CSW Orkney Grey

I'm afraid I can't help with your queston but sure some experts will be along shortly. But welcome to D2N

James
MY2012 110 2.2TDCi XS SW Orkney Grey - http://www.defender2.net/forum/topic43410.html
MY1990 110 200TDi SW beautifully faded Portofino Red - https://www.defender2.net/forum/post743641.html#743641
MY1984 90 V8 Slate Grey - https://www.defender2.net/forum/post744557.html#744557
Instagram @suffolk_rovers

11th Dec 2020 5:25pm

Dinnu

Member Since: 24 Dec 2019
Location: Lija
Posts: 3414

2012 Defender 90 Puma 2.2 CSW Santorini Black

When you press the clutch pedal, the clutch release bearing is working, and all gearbox bearings would stop or at least slow down. All gearbox bearings will stop once you engage a gear and the vehicle is still stationary.

On the other hand, the input shaft is rotating, but so is the layshaft and all the gears inside the gearbox when the clutch pedal is released. With clutch pedal released, the clutch release bearing is not rotating (at least not under load).

So from your description I am afraid it could be the gearbox.

Have you dropped the oil to check the quality of the oil? If you re fill it, everyone states to refill 2.2liters. My manual says 2.4liters (2012). 1988 90 Hard Top, 19J Diesel Turbo, Shire Blue - Restoration ongoing
2012 90 CSW, 2.2TDCI, Santorini Black

11th Dec 2020 5:34pm

Page 1 of 1

All times are GMT

Jump to

< Previous Topic | Next Topic >

Posting Rules

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum