DEFENDER2.NET - View topic - Clunk Free Gear Change

↓ Advertise on Defender2 ↓

Home · FAQ · New Posts · My Posts · PMs · Search · Members · Map · Calendar · Profile · Donate · Register · Log In

Home > Puma (Tdci) > Clunk Free Gear Change

Page 1 of 1

Print this entire topic ·

Morepower

Member Since: 08 Jan 2013
Location: Fife, Scotland
Posts: 630

Clunk Free Gear Change

That's right... Clunk free gear changes are possible... This is what I've done to my 13my110 to get it sorted...

Replaced rear drive shafts with single piece 16my drive shafts/ I think they are also the same a discovery 2 drive shafts..Then fitted an Ashcroft transfer shaft whilst the gearbox was out AGAIN for it's 3rd clutch in 31000miles... Replaced this time with a SACHS clutch kit (Dargel recommended)... Which seems 10-15% lighter in operation... Then a BAS quickshift kit.... The gearchange and 'throttle' connection to the wheels is much better, On/off has no clunk now either... Next is a double carden front propshaft to remove the drivetrain vibration at 45mph...

Regards

Tim It doesn't matter how bad it is, It can always get worse...

2013 Bowler 110 (Sold)
2016 Bowler 90 Rally Spec (Sold)

26th Nov 2016 4:06pm

defender9

Member Since: 12 Mar 2016
Location: Fylde Coast
Posts: 1629

2015 Defender 90 Puma 2.2 SW Keswick Green

Interesting post Tim. I have a 15 plate Puma, when did the 16MY actually start and can you tell from looking externally which drive shafts you have?

Thanks
John

26th Nov 2016 4:32pm

Devon-Rover

Member Since: 22 Jan 2015
Location: South Devon
Posts: 914

2014 Defender 110 Puma 2.2 USW Aintree Green

You can tell the model year through the VIN plate after the usual SALL.... your VIN will then give two letters before the last set of 6 numbers so DA189345 or EA097395 or FA873026 It is this that gives the year:

2012 - CA
2013 - DA
2014 - EA
2015 - FA
2015 - GA
2016 - HA

The rear drive flanges referred to go from the separate one from the shaft which have the rubber cap on the end. To an all in one flange and shaft.

26th Nov 2016 6:17pm

defender9

Member Since: 12 Mar 2016
Location: Fylde Coast
Posts: 1629

Thanks Devon-Rover, looking at the V5 mine is GA so 15MY. I will have a look at the drive shafts tomorrow to confirm.

27th Nov 2016 6:02pm

Page 1 of 1

All times are GMT

Jump to

< Previous Topic | Next Topic >

Posting Rules

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum