↓ Advertise on Defender2 ↓

Home > Puma (Tdci) > Vibration / Rattle
Post Reply  Down to end
Page 1 of 1
Print this entire topic · 
schuee



Member Since: 16 Jul 2012
Location: Lincolnshire
Posts: 378

United Kingdom 2011 Defender 110 Puma 2.4 USW Orkney Grey
Vibration / Rattle
Lately I have noticed a vibration in the drive train mainly when changing through the gears, all I can describe it like is when you accidently change into too high a gear say changing into 5th gear when you meant to change into 3rd and then the revs are not high enough and you experience a vibration until your up to speed.
So this morning I put the transfer box into neutral and changed through the gears, reverse 1st, 2nd and 3rd no vibration at all, then when in 4th vibration starts a little until when in 6th there is a right clatter and vibration from below just under the cubby box area, I will have a look underneath later, though before that just wondering if the good people on DEF2 had any thoughts.

Cheers

Keith
Post #318082 22nd Mar 2014 11:24am
View user's profile Send private message View poster's gallery Reply with quote
bpman



Member Since: 21 May 2008
Location: Oslo
Posts: 8069

2008 Defender 110 Puma 2.4 SVX Station Wagon Santorini Black
check your propshafts and UJ's

have you modified the suspension ?
Post #318173 22nd Mar 2014 7:03pm
View user's profile Send private message View poster's gallery Reply with quote
custom90



Member Since: 21 Jan 2010
Location: South West, England.
Posts: 20453

United Kingdom 
Are you sure it's not the Gearstick rattle issue? No Guts, No Glory.
🇬🇧🏴󠁧󠁢󠁥󠁮󠁧󠁿🏴󠁧󠁢󠁷󠁬󠁳󠁿🏴󠁧󠁢󠁳󠁣󠁴󠁿🇮🇪🇺🇸⛽️🛢️⚙️🧰💪
Post #318179 22nd Mar 2014 7:15pm
View user's profile Send private message View poster's gallery Reply with quote
Skeggy 90



Member Since: 07 Oct 2013
Location: Skeg Vegas
Posts: 233

England 2011 Defender 130 Puma 2.4 SW Bali Blue
When you ran it up with the transfer box in neutral did it vibrate in 5th gear, as this is direct drive on the MT82, if it did you can rule out the gearbox. It would be worth getting someone to drive the car up in neutral and feel both front and rear propshafts to see if they are vibrating, also check if it does it in low range.
Post #318205 22nd Mar 2014 8:26pm
View user's profile Send private message View poster's gallery Reply with quote
schuee



Member Since: 16 Jul 2012
Location: Lincolnshire
Posts: 378

United Kingdom 2011 Defender 110 Puma 2.4 USW Orkney Grey
Thanks for the advice all, I will check the propshafts and UJ's though nothing modified on the suspension, also not heard anything before regarding gearstick rattle ?

When transfer box in neutral and in fifth gear it does rattle, what I did notice is that by dipping the clutch it stopped and letting it back out the rattle / vibration returned, also forgot last week that in low box 1st gear drive was erratic with rattle noise, though tried it this morning and it seemed OK, well it is a Defender Laughing

I had the clutch replaced around 20,000 because of the rattling springs, which cured that and also I did have it in for the transmission brake binding a few times, which was sorted though since then I need to apply handbrake with more clicks than I would expect to hold vehicle.

Cheers

Keith
Post #318329 23rd Mar 2014 10:58am
View user's profile Send private message View poster's gallery Reply with quote
schuee



Member Since: 16 Jul 2012
Location: Lincolnshire
Posts: 378

United Kingdom 2011 Defender 110 Puma 2.4 USW Orkney Grey
Well I took the 110 to the dealer during the week, and they accompanied me on a road test, could possibly be another clutch replacement on the books. It had a new clutch in around 20,000 miles which sorted out the clanging rattle whilst idling. The technician said there would have been uprated clutch's available since then, I did mention to him about the heavy duty clutch, though he did say that it would make the clutch pedal heavy to use
Also booked in for injector pilot learning, rear half shaft's replacement, rear diff pinion oil seal renewal due to a leak, and new side runner due to paint flaking off.

Getting all this done before the warranty expires, must say my dealer have been excellent regarding any issue's and getting warranty work carried out Thumbs Up
Out of curiosity has anyone had the heavy duty clutch fitted, and what would be the benefits?

Cheers
Keith
Post #321797 5th Apr 2014 8:11pm
View user's profile Send private message View poster's gallery Reply with quote
MK



Member Since: 28 Aug 2008
Location: Santiago
Posts: 2422

Chile 2007 Defender 110 Puma 2.4 SW Chawton White
As far as I know there no such thing like a HD clutch for the Puma. I understand Porny is working on some of this HD clutch idea. Puma 110" SW

.............................................................
Earth first. Other planets later
Post #321812 5th Apr 2014 9:46pm
View user's profile Send private message View poster's gallery Post Reply
Post Reply  Back to top
Page 1 of 1
All times are GMT

Jump to  
Previous Topic | Next Topic >
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



Site Copyright © 2006-2024 Futuranet Ltd & Martin Lewis
DEFENDER2.NET RSS Feed - All Forums