DEFENDER2.NET - View topic - Why motor goes into limp mode when needle risers

↓ Advertise on Defender2 ↓

Home · FAQ · New Posts · My Posts · PMs · Search · Members · Map · Calendar · Profile · Donate · Register · Log In

Home > Puma (Tdci) > Why motor goes into limp mode when needle risers

Page 1 of 1

Print this entire topic ·

rillas

Member Since: 27 May 2012
Location: warilla nsw 2528
Posts: 16

Why motor goes into limp mode when needle risers

Why does my 2.2 heat needle goes up just after Limp mode kicks in sit for 20 mins needle drops no water loss and drives off if nothing was wrong new water pump new silicon hoses new thermostat new bowl cup please help I am at send

5th Jun 2023 8:45am

andydef90

Member Since: 09 Feb 2015
Location: yorkshire
Posts: 617

2014 Defender 90 Puma 2.2 HT Corris Grey

hi is your water flowing in your radiator expansion tank worth a look iv seen thermostats put in upside down . check the finials is clean in you radiator too .

Regards

Andy

5th Jun 2023 3:13pm

Ianh

Member Since: 17 Sep 2018
Location: Essex
Posts: 2004

Have you a code reader to obtain the Diagnostic Trouble Code(s) that are triggering the limp mode ?

Also, on the 2.2 you have a coolant temperature sensor, so worth checking that and it’s wiring are ok.

See https://www.defender2.net/forum/post390785.html second post down has a diagram on location.

5th Jun 2023 4:12pm

rillas

Member Since: 27 May 2012
Location: warilla nsw 2528
Posts: 16

Thanks will check out weekend

7th Jun 2023 11:17am

Page 1 of 1

All times are GMT

Jump to

< Previous Topic | Next Topic >

Posting Rules

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum