DEFENDER2.NET - View topic - 9 months old, 12,000 miles and corrosion in full swing.

↓ Advertise on Defender2 ↓

Home · FAQ · New Posts · My Posts · PMs · Search · Members · Map · Calendar · Profile · Donate · Register · Log In

Home > Maintenance & Modifications > 9 months old, 12,000 miles and corrosion in full swing.

Page 1 of 2

Print this entire topic ·

Jim_Bean

Member Since: 10 May 2011
Location: Staffordshire / Shropshire border
Posts: 613

2013 Defender 110 Puma 2.2 XS CSW Santorini Black

9 months old, 12,000 miles and corrosion in full swing.

So she's 9 months old as just coming up for 12,000 miles and her first service. I Dinitrolled her in her first week but didn't get around to doing the ACF50 on the hinges and bodywork until this week end

When I started to go around the hinges, capping, steps and rivets I noticed there is already quite a bit of rust and paint bubbles.

Front passenger side windscreen 'hinge' :

Click image to enlarge

Rear step:

Click image to enlarge

Under rear step:

Click image to enlarge

And quite worryingly a red rust leak that looks like a coolant leak of some sort has appeared on the bottom right hand side of the radiator on top of the chassis (which is covered in dinitrol).

Click image to enlarge

When she goes in next week for her first service will I be able to get the hinge and rear step replaced under warranty?

Is £375 for the service about right?

What does the anti-corrosion warranty cover? Should I expect some resistance from the dealer?

Are there any other common issues I should check out?

Its disappointing (not surprising) to see such a level of rot after 9 months. I live in the midlands, not next to the sea! I wish i'd followed Zagato's advice and applied the ACF50 much much earlier.

I'm hoping the dealer (Shukers in Shrewsbury) will fix these issues under the warranty but any guidance on how best to approach this would be gratefully accepted.

Jim

31st Mar 2014 3:20pm

AlisterC

Member Since: 25 Apr 2012
Location: Somerset
Posts: 116

2011 Defender 90 Puma 2.4 XS CSW Indus Silver

You should not have any issues at all in getting it all done under warranty

Mine went in exactly the same places, and they replaced them with no argument at all.

Just give it a good look over before the service and point out every little thing. Including the bumper bolts, rear cross member bolts etc.

the only problem is they will replace the bolts with the exact same rubbish, and they will rust again in a few months.

31st Mar 2014 3:25pm

custom90

Member Since: 21 Jan 2010
Location: South West, England.
Posts: 20340

That isn't good enough for the age or miles at all. Mines just over six years old and 30k and it's not as bad as that in those locations. And that's before bring Dinitrolled too.
They should sort that out for you, if they want to replace with the safe rubbish source the items yourself and ask them to fit it...

31st Mar 2014 3:34pm

Jim_Bean

Member Since: 10 May 2011
Location: Staffordshire / Shropshire border
Posts: 613

I'm going to go back out and check the mirror arms and sliding window hinges.

I'll check the bumper bolts as well. I'm hoping this is the source of the red leak on the front chassis member!

Reading throughout the forum it does seem like people are getting these issues sorted out but the dealers. It just seems crazy that there is so little anti corrosion protection put in place a the factory.

31st Mar 2014 3:39pm

GUM97

Member Since: 05 Feb 2012
Location: Cheshire
Posts: 3555

1997 Defender 90 300 Tdi HT Stornoway Grey

£375 isn't too bad for 1st service.
Take a look at this thread with price comparisons on:
http://www.defender2.net/forum/topic26023.html An engine to TDi for!
"Land Rover- Proudly turning drivers into mechanics since 1948"

31st Mar 2014 3:50pm

munch90

Member Since: 26 Oct 2013
Location: guildford
Posts: 3558

the red dust is because there is a bolt missing through the hole you can see just behind front panel . the hole is for one of the bonnet lock panel stays or for aircon rad mount frame , should be m8 bolt in there . the hole is bigger than 8mm but that's what it has.
the dust is rust dust where the bracket has been vibrating

and to be honest it needs a lot more rustproofing done

Last edited by munch90 on 31st Mar 2014 3:58pm. Edited 1 time in total

31st Mar 2014 3:51pm

munch90

Member Since: 26 Oct 2013
Location: guildford
Posts: 3558

£375 for oil and filter change , you used to get first service free

31st Mar 2014 3:56pm

Jim_Bean

Member Since: 10 May 2011
Location: Staffordshire / Shropshire border
Posts: 613

Thanks for the feedback guys. Feel a bit better about the £375 now.

Yes, I agree. I didn't do the Dinitrolling even close to well enough

I'm a newbie at this and though I had soaked the thing in Dinitrol

I will try and get the grille off tonight and check for the missing M8 bolt. It was missing 3 bolts holding the rear seats in when I first got it so a few more is no surprise!

I guess i'll under there again in the dry weather and adding A LOT more Dinitrol and A LOT of ACF50.

God knows what i would have looked like if i'd done nothing at all!

31st Mar 2014 4:07pm

Joe the Plumber

Member Since: 18 Dec 2013
Location: Midlands
Posts: 907

2014 Defender 110 Puma 2.2 HT Fuji White

There are some other corrosion treatment and prevention products you might consider here Jim:

www.bilthamber.com

31st Mar 2014 7:24pm

Jim_Bean

Member Since: 10 May 2011
Location: Staffordshire / Shropshire border
Posts: 613

Thanks Joe, just taking a look now.

31st Mar 2014 8:41pm

Happyoldgit

Member Since: 14 Sep 2007
Location: Norfolk
Posts: 3471

2015 Defender 110 Puma 2.2 USW Corris Grey

Looks like all the usual places. Also check the rear edge of the bumper, bulkhead area where the screen block bolts are on the inside and along the length of the foam seal [pop out the lower dash speakers], side steps / bars, towbar etc..... Steve.
Owned numerous Land Rover vehicles of all shapes and sizes over the decades.
Current Defender: A non tarts hand-bagged Puma 110 XS USW.

[Insert something impressive here such as extensive list of previous Land Rovers or examples of your prestigeous and expensive items, trinkets, houses, bikes, vehicles etc]

http://forums.lr4x4.com

I used to be Miserable ...but now I'm ecstatic.

1st Apr 2014 10:53am

Happyoldgit

Member Since: 14 Sep 2007
Location: Norfolk
Posts: 3471

1st Apr 2014 10:53am

JR

Member Since: 07 Dec 2012
Location: Auchtermuchty
Posts: 532

1984 Defender 90 200 Tdi SW Coniston Green

also check the headlight trim rings, they always seem to corrode. ours did!

1st Apr 2014 7:21pm

JR

Member Since: 07 Dec 2012
Location: Auchtermuchty
Posts: 532

also check the headlight trim rings, they always seem to corrode. ours did!

1st Apr 2014 7:22pm

JR

Member Since: 07 Dec 2012
Location: Auchtermuchty
Posts: 532

also check the headlight trim rings, they always seem to corrode. ours did!

1st Apr 2014 7:23pm

Page 1 of 2

All times are GMT

Jump to

< Previous Topic | Next Topic >

Posting Rules

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum