DEFENDER2.NET - View topic - Nanacom question for TD5 2001 90

↓ Advertise on Defender2 ↓

Home · FAQ · New Posts · My Posts · PMs · Search · Members · Map · Calendar · Profile · Donate · Register · Log In

Home > Td5 > Nanacom question for TD5 2001 90

Page 1 of 1

Print this entire topic ·

MC84

Member Since: 22 May 2016
Location: Near Bristol
Posts: 360

Nanacom question for TD5 2001 90

Hi, I have a TD5 90 2001 with a 10P engine. The ECM is a non-programmable MSB variant.

I own a Nanacom diag system and want to know if I can read the crank position with it?

I’ve not been able to find anything in the Nanocom system to let me do this. I’m currently having an issue with starting the truck and want to eliminate the crank/fly wheel sensor. There is nothing in the fault codes for any issue with it but if I disconnect the sensor I still don't get a code error.

Can it be read with the setup I have?

Thanks in advance. Mike

Hard Top 90 TD5 2001
Ford 100e 1959
www.youtube.com/mikemakesit

11th Nov 2024 6:10am

Newlandy

Member Since: 01 Apr 2024
Location: Gauteng
Posts: 7

Hi, if the CPS is an issue, one usually gets a "crank noisy " fault message on nanocom.
Try cleaning the CPS and move the CPS wire as far away from the starter motor as possible. Sometimes the signal is corrupted by the starter electrics.

While you're at it, clean AFM,MAP, IAT sensors as well, not that it will solve the problem but it's good to start with a clean slate.

14th Nov 2024 8:37am

TexasRover

Member Since: 24 Nov 2022
Location: Paris
Posts: 1084

2002 Defender 110 Td5 DCPU Chawton White

Nanocom can display engine speed (rpm) which is generated by the crank sensor. If the crank sensor is your cause of non-start (quite a likely scenario tbh) you will see the rpm stay at 0 or jumping all over place while cranking

14th Nov 2024 10:54am

Newlandy

Member Since: 01 Apr 2024
Location: Gauteng
Posts: 7

If you want to test the CPS you can test it by measuring the Ohm between the connectors directly on the sensor, and it should read around 1.2 Ohm.

14th Nov 2024 11:21am

MC84

Member Since: 22 May 2016
Location: Near Bristol
Posts: 360

Thanks for the info guys, much appreciated

Mike

Hard Top 90 TD5 2001
Ford 100e 1959
www.youtube.com/mikemakesit

14th Nov 2024 6:54pm

Page 1 of 1

All times are GMT

Jump to

< Previous Topic | Next Topic >

Posting Rules

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum