↓ Advertise on Defender2 ↓

Home > Puma (Tdci) > Alarm Immobiliser
Post Reply  Down to end
Page 1 of 1
Print this entire topic · 
audi1boy



Member Since: 11 Dec 2020
Location: Somerset
Posts: 24

United Kingdom 2008 Defender 130 Puma 2.4 HCPU Barolo Black
Alarm Immobiliser
Good morning,

So I have a 2015 2.2 TDCI Puma Defender 130.

The issue has been with the alarm and immobiliser. I believe the battery was drained and not replaced correctly.

At first the alarm would go off randomly even when driving. Sometimes the main alarm and sometimes the passive alarm. Recently though the car has immobilised itself and the only way to start is to do the negative terminal trick. I won't share on here but those who know know.

I have hooked the truck up to Nanocom Evolution and it won't communicate with the Immobiliser.

I have checked all of the door and bonnet switches and all are working fine. All doors lock and unlock with the key fob. I have checked the roof lining sensor and disconnected it and no improvement. I have tried syncing the key fob doing the unlock and lock method and nothing. Also tried just using that method with the key and not the fob and nothing.

The key fob will lock and unlock the doors but the car is immobilised.

If it is the immobiliser can i buy a new one and reprogram with the Nanocom? Or any other suggestions as how to sort?

Nanocom won't seem to read the EKA code either. It's fully unlocked it just won't read it.

Thanks
Post #1043286 20th Aug 2024 10:16am
View user's profile Send private message View poster's gallery Reply with quote
jim4244



Member Since: 13 Apr 2014
Location: Bedfordshire
Posts: 773

England 2007 Defender 90 Puma 2.4 CSW Zermatt Silver
Hi

I had a problem with a 10AS module fitted to a TD5 a few years ago.

I removed it and sent it to the chap below for reprograming / repair. I think that it cost £75 including refurbishment of the blipper fobs.

https://www.technozen-electronics.co.uk/la...-services/

Drop him a line explaining the symptoms.

Jim
Post #1043288 20th Aug 2024 10:53am
View user's profile Send private message View poster's gallery Reply with quote
audi1boy



Member Since: 11 Dec 2020
Location: Somerset
Posts: 24

United Kingdom 2008 Defender 130 Puma 2.4 HCPU Barolo Black
Thanks Jim. I will ask the question. I have the later immobiliser I think which is a black box rather than the 10AS.
Post #1043289 20th Aug 2024 10:56am
View user's profile Send private message View poster's gallery Reply with quote
Ianh



Member Since: 17 Sep 2018
Location: Essex
Posts: 1981

United Kingdom 
You will have the later ALM module. It’s likely that you have the DHxxxxxxxxx serial number version, however you may have the earlier ALM CHxxxxxx Version. If you have the CH version it can suffer from a brownout issue if the starter battery is allowed to slowly drain to low volts, this causes some of the ALM software to be corrupted.

Best have a chat with remotekey https://www.remotekey.co.uk/shop/land-rove...trol-ecus/

You can see what unit you have by removing the drivers footwell speaker and looking up.
Post #1043292 20th Aug 2024 11:56am
View user's profile Send private message View poster's gallery Post Reply
Post Reply  Back to top
Page 1 of 1
All times are GMT

Jump to  
Previous Topic | Next Topic >
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



Site Copyright © 2006-2024 Futuranet Ltd & Martin Lewis
DEFENDER2.NET RSS Feed - All Forums