↓ Advertise on Defender2 ↓

Home > Puma (Tdci) > ABS Problem
Post Reply  Down to end
Page 1 of 1
Print this entire topic · 
mrfirepro



Member Since: 06 Nov 2020
Location: kent
Posts: 230
United Kingdom 1996 Defender 90 300 Tdi HT Bonatti Grey
ABS Problem
I recently overhauled the complete braking system on my 2007 2.4 Tdci, whilst there I replaced all the bearings.

I'm now getting the following fault on my ABS system

16-07 Front Left sensor output too low - Intermittent - happened 16 times

I've changed the sensor and still have the fault, before I go any further are there any suggestions of anything I could have done wrong with the bearing to cause this fault as it was fine before I replaced the brakes and bearing.

Any help much appreciated
Post #1025573 22nd Feb 2024 9:56am
View user's profile Send private message View poster's gallery Reply with quote
geobloke



Member Since: 06 Nov 2012
Location: Nottinghamshire
Posts: 4410
United Kingdom 
It sounds like there isn't enough voltage being registered by the ECU coming back from the sensor. So first step would be check and clean the earths.

Next step would be to check the loom and connections for corrosion.

After that I would check the voltage output of the opposite wheel sensor and see how much lower the bad one is.

Let us know how you get on. Interesting problem, not seen this one before.
Post #1025576 22nd Feb 2024 10:13am
View user's profile Send private message View poster's gallery Reply with quote
blackwolf



Member Since: 03 Nov 2009
Location: South West England
Posts: 17383
United Kingdom 2007 Defender 110 Puma 2.4 DCPU Stornoway Grey
Another possibility is that the senor is not close enough to the reluctor ring, which would result in the inducted voltage in the sensor being lower than normal. It may be as simple as giving the sensor a gentle tap into the swivel pin.
Post #1025583 22nd Feb 2024 10:29am
View user's profile Send private message View poster's gallery Reply with quote
geobloke



Member Since: 06 Nov 2012
Location: Nottinghamshire
Posts: 4410
United Kingdom 
Good call Blackwolf Thumbs Up
Post #1025584 22nd Feb 2024 10:30am
View user's profile Send private message View poster's gallery Reply with quote
Screbble



Member Since: 26 Apr 2015
Location: Lancashire
Posts: 2102
United Kingdom 2004 Defender 90 Td5 XS CSW Zambezi Silver
I had that issue and as described a gentle tap (be careful) resolved it.

The sensors themselves are relatively inexpensive and plug and play - albeit you will need to throughly clean the surrounding areas and locating hole.
Post #1025825 24th Feb 2024 1:07pm
View user's profile Send private message View poster's gallery Post Reply
Post Reply  Back to top
Page 1 of 1
All times are GMT

Jump to  
<  Previous Topic | Next Topic >
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



Site Copyright © 2006-2024 Futuranet Ltd & Martin Lewis
DEFENDER2.NET RSS Feed - All Forums