DEFENDER2.NET - View topic - clutch height adjustment

↓ Advertise on Defender2 ↓

Home · FAQ · New Posts · My Posts · PMs · Search · Members · Map · Calendar · Profile · Donate · Register · Log In

Home > Technical > clutch height adjustment - rubber mats

Page 1 of 1

Print this entire topic ·

Gasket

Member Since: 30 May 2020
Location: Manchester
Posts: 629

clutch height adjustment - rubber mats

Hi folks. I've just fitted a wright off road mat to the Puma defender (2010, 2.4) and noticed that the clutch pedal is hitting the mat when fully depressed.

Before fitting I had checked the pedal height to make sure it was at factory settings and was all correct (140mm from bare floor plate to base of bare pedal).

The brake and throttle pedals are obviously miles clear of the mat - its just the clutch.

So, is it just a case of adjusting the pedal to raise the lower stop a little to ensure it clears the mat?

27th Oct 2022 2:31pm

Mo Murphy

Member Since: 01 Jun 2008
Location: Letchworth Garden City, Herts
Posts: 2229

1984 Defender 90 BMW M57 3.0 Diesel HT Auto Pennine Grey

Wind the pedal stop bolt in until the pedal clears, then check Clutch operation. Adjust if necessary but don't get too hung up on the 140mm measurement, it's a guide.
Mo The Land Rover 90 - Many are called, few are chosen.

50 Shades of Pennine Grey

27th Oct 2022 4:36pm

Page 1 of 1

All times are GMT

Jump to

< Previous Topic | Next Topic >

Posting Rules

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum