DEFENDER2.NET - View topic - Will crank, won't start

↓ Advertise on Defender2 ↓

Home · FAQ · New Posts · My Posts · PMs · Search · Members · Map · Calendar · Profile · Donate · Register · Log In

Home > Puma (Tdci) > Will crank, won't start

Page 1 of 1

Print this entire topic ·

The Gudgeon

Member Since: 18 Jul 2021
Location: Devon
Posts: 2

2008 Defender 110 Puma 2.4 CSW Barolo Black

Will crank, won't start

Hi Guys, 2.4tdci in an 08 Defender. Just had clutch and slave replaced last week. Vehicle ran fine on completion ,2 days later it just wont start on the key, it turns over but won't fire, I can start it by bumping and if I spray easistart at it runs cup fine. I have renewed the 5 micron and have run it up since on easistart. Anyone got any ideas I would appreciate your comment. All relays and fuses checked but I havent checked the connections on the green unit behind the RH speaker yet.

20th Jul 2021 3:50pm

Badger110

Member Since: 06 Feb 2018
Location: South hams
Posts: 1039

2011 Defender 110 Puma 2.4 USW Buckingham Blue

Whereabouts in Devon are you?

20th Jul 2021 6:00pm

The Gudgeon

Member Since: 18 Jul 2021
Location: Devon
Posts: 2

Near Tavy, I ran the Bearmach diagnostic tool on it today and there were no codes. It showed that I had 65000kPa on the fuel rail and I am led to believe that you should see a minimum of 54k. So it appears not to be a fuel problem. As the clutch was recently changed I've ordered a crank position sensor which I'll fit tomorrow. At this point I am out of my depth as if the cps is sending the correct signal to the ECU where do you go from here? any comment would be appreciated. Update, I removed and refitted the original CPS and it started first time.

20th Jul 2021 6:18pm

Page 1 of 1

All times are GMT

Jump to

< Previous Topic | Next Topic >

Posting Rules

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum