Member Since: 31 Aug 2016
Location: London
Posts: 18
Rubber grommets for safari snorkel holes
Hi,
Going to remove my safari snorkel soon and I believe there will be some holes in the wing to fill, I was going to use rubber grommets but would love to know what size to get before I do it! HELP please!!
Simon
Click image to enlarge
31st Aug 2016 4:34pm
Rodney-too
Member Since: 04 Jun 2016
Location: Cornwall
Posts: 62
I did the same; as the holes have rivnuts I just put the bolts back in, with some copper slip to stop corrosion, and have left then in. Wth all the rivets and spot welds dents, it doesn't look too bad. Will get a photo when it's not dark!
14th Sep 2016 7:26pm
sjwdrew
Member Since: 31 Aug 2016
Location: London
Posts: 18
safari snorkel
Hi,
Did you remove it via the wheel arch? Also what is all this about drain valves?
Simon
20th Sep 2016 9:35pm
Rodney-too
Member Since: 04 Jun 2016
Location: Cornwall
Posts: 62
Sorry for the delay; mine is an OE RAI so attached using 2 rivnuts in the wing above the air vent, so could be removed from the front. I have left the rovnuts in for now, as I need to get the wing resprayed where the RAI has rubbed the paints and primer down to bare metal!
Drain holes? Probably some in the air Box? Out of interest, when I removed the RAI the bottom of it was full of water!
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
14th Sep 2016 7:26pm
