DEFENDER2.NET - View topic - Dog Guard fitting in a 90 CSW: Help!

↓ Advertise on Defender2 ↓

Home · FAQ · New Posts · My Posts · PMs · Search · Members · Map · Calendar · Profile · Donate · Register · Log In

Home > Maintenance & Modifications > Dog Guard fitting in a 90 CSW: Help!

Page 1 of 1

Print this entire topic ·

RRUK
Site Supporter

Member Since: 31 Mar 2010
Location: Leicestershire
Posts: 2025

Dog Guard fitting in a 90 CSW: Help!

So I now have my hands on a genuine LR006448 part dog guard that should fit my car, it came complete with brackets however mine already has them installed.

I printed out the LR Accessory install pages and I can see how it SHOULD all go it, but it doesn't line up at all. I can get the two tie bars on it that are attached to the wheel arch sides, but after that, nothing lines up.

There's two brackets on top of the wheel arches behind the front seats, the instructions show the dog guard in front of these but that's completely impossible due to the tubular bulkhead removal bar. Then the two brackets by the alpine lights are inches away too.

Can anyone offer any advice on this one? If I lose patience I will sell it on!

has anyone got one fitted in a 90 CSW with the bulkhead removal bar behind the seats? 2016 D4 HSE

1998 110 TUM HS FFR Hard Top XD WOLF

1982 Series 3 SWB Petrol

3rd Aug 2015 3:58pm

consumerize

Member Since: 27 May 2014
Location: Berkshire
Posts: 121

I have this mine. its a bit fiddly until you work out where stuff goes. The bottom goes behind the bulkhead removal bars. but in front of the bracket. pictures here showing the left hand side looking from the back.

Click image to enlarge

The top section goes agains the reader side of the bracket, screwing in from the front.

Click image to enlarge

The bottom of the top pic sits on the bottom piece, forward of the screw brackets.

Click image to enlarge

Do everything up real loos to start, then tighten it up. If all else fails take the brackets that are in there out, and use the proper ones.

3rd Aug 2015 7:03pm

RRUK
Site Supporter

Member Since: 31 Mar 2010
Location: Leicestershire
Posts: 2025

I just don't see how you've managed to put the dog guard in front of the bracket on the wheel arch and yet at the same time behind the tubular bar.

In this photo below you can see that both in mine are in line with each other. This is why I can't get it to fit.

Click image to enlarge 2016 D4 HSE

1998 110 TUM HS FFR Hard Top XD WOLF

1982 Series 3 SWB Petrol

10th Aug 2015 11:25am

Page 1 of 1

All times are GMT

Jump to

< Previous Topic | Next Topic >

Posting Rules

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum