Author |
Message |
Transmission Noise / Issue |
ozzie1989
20th Jan 2024 8:52pm
|
Forum: Puma (Tdci) · Replies: 4 · Views: 1254 · Subject: Transmission Noise / Issue |
Sadly not, I stripped and rebuilt the front axle on both sides and swapped the diff for an ATB from Ashcroft's.
The 2 pin diff that came out was actually in very good condition so definitely wasn't ... |
I wouldn't normally do this but... what's this noise? |
ozzie1989
10th Sep 2021 7:27pm
|
Forum: Maintenance & Modifications · Replies: 6 · Views: 2129 · Subject: I wouldn't normally do this but... what's this noise? |
Thank you all so much for taking the time to reply.
Lots to check from your suggestions so will have a look on the weekend and report back if I find anything |
I wouldn't normally do this but... what's this noise? |
ozzie1989
9th Sep 2021 9:08pm
|
Forum: Maintenance & Modifications · Replies: 6 · Views: 2129 · Subject: I wouldn't normally do this but... what's this noise? |
Ok so I'm using this as a last resort. Asking people on a forum for help with a noise is usually frowned upon, but even if just one person suggests something that may help you may just make my day :b ... |
What supports the driveshaft at the axle tube end? |
ozzie1989
28th Jul 2021 8:47am
|
Forum: Maintenance & Modifications · Replies: 5 · Views: 1392 · Subject: What supports the driveshaft at the axle tube end? |
Great, thanks for confirming.
The noise must be coming from the diff then, so may need to remove and check it |
What supports the driveshaft at the axle tube end? |
ozzie1989
28th Jul 2021 5:27am
|
Forum: Maintenance & Modifications · Replies: 5 · Views: 1392 · Subject: What supports the driveshaft at the axle tube end? |
If you remove the stub axle the short end of the shaft/CV moves freely whereas the other end is held perfectly in the centre of the cup.
You'd think there was a bearing there but it could just be ... |
What supports the driveshaft at the axle tube end? |
ozzie1989
27th Jul 2021 9:58pm
|
Forum: Maintenance & Modifications · Replies: 5 · Views: 1392 · Subject: What supports the driveshaft at the axle tube end? |
Hi all, strange question but...
I've just rebuilt the entire passenger side from stub axle out due to what sounds like a bearing rumble, squeak and occasionally as you come to a stop a vibrating ac ... |
Transmission Noise / Issue |
ozzie1989
10th Jul 2021 9:46pm
|
Forum: Puma (Tdci) · Replies: 4 · Views: 1254 · Subject: Transmission Noise / Issue |
Hi all, this is a bit of a long one so apologies, but I wanted to give the full story about my 110 Defender USW 2.4 with 60k on the clock.
Recent work includes: new TB output flange and handbrake a ... |
Handbrake issue and advice on removal of rear output flange |
ozzie1989
3rd Jun 2021 9:40pm
|
Forum: Puma (Tdci) · Replies: 7 · Views: 2808 · Subject: Handbrake issue and advice on removal of rear output flange |
Quick update, on stripping down it was clear to see the oil was coming from the seal on the surface where the shaft runs through it.
It had coated everything in the handbrake in a lovely film of s ... |
Rattling pads driving me crazy! |
ozzie1989
31st May 2021 7:13am
|
Forum: Puma (Tdci) · Replies: 2 · Views: 1041 · Subject: Rattling pads driving me crazy! |
Thank you so much! Can't quite figure out why that didn't come up on the search, especially as it's so recent!
|
Rattling pads driving me crazy! |
ozzie1989
30th May 2021 11:18pm
|
Forum: Puma (Tdci) · Replies: 2 · Views: 1041 · Subject: Rattling pads driving me crazy! |
Hi all, my brake pads are rattling again front and rear. It's driving me crazy now with the windows down...
I'm sure someone here suggested you can buy the anti-rattle shims somewhere or, alternati ... |
Can anyone recommend a retrofit AC kit? |
ozzie1989
30th May 2021 11:08pm
|
Forum: Puma (Tdci) · Replies: 3 · Views: 1389 · Subject: Can anyone recommend a retrofit AC kit? |
I bought a kit from Bearmach (on offer) that turned out to be a Cool Air Logan kit.
Very hard to tell apart from the genuine setup (apart from grille of course) and uses genuine AC hoses and compre ... |
Handbrake issue and advice on removal of rear output flange |
ozzie1989
30th May 2021 11:05pm
|
Forum: Puma (Tdci) · Replies: 7 · Views: 2808 · Subject: Handbrake issue and advice on removal of rear output flange |
Sorry to bring this back up but after 6 months I've got oil leaking into the hand brake drum.
I'm guessing that the pattern parts I fitted have failed or something has gone amiss so I need to strip ... |
Britpart one price halfshafts |
ozzie1989
14th Mar 2021 7:00pm
|
Forum: Puma (Tdci) · Replies: 24 · Views: 7275 · Subject: Britpart one price halfshafts |
Another vote for the Britpart shafts, not had any issues.
Same for shocks, springs etc. I've used over the years. Just don't trust their filters personally but then I had two bearmach filters fail ... |
SD Roll Cage Internal Hoop |
ozzie1989
6th Mar 2021 9:58pm
|
Forum: Maintenance & Modifications · Replies: 13 · Views: 3689 · Subject: SD Roll Cage Internal Hoop |
Is that the one you bought from me James?
How do you find it and, out of interest, did you cover it in foam or anything to prevent a head injury during an accident?
For anyone else if that hoop ... |
Back Puma 90 |
ozzie1989
25th Feb 2021 7:53am
|
Forum: My Defender · Replies: 65 · Views: 19254 · Subject: Back Puma 90 |
Quite a few recent threads on 18's in the wheel and tyre section, may be worth reading a few of those
https://www.defender2.net/forum/wheels-tyres-vf48.html
If your off roading is g ... |
|