DEFENDER2.NET - View topic - Td5 Anti Stall

↓ Advertise on Defender2 ↓

Home · FAQ · New Posts · My Posts · PMs · Search · Members · Map · Calendar · Profile · Donate · Register · Log In

Home > Td5 > Td5 Anti Stall - not working right?

Page 1 of 1

Print this entire topic ·

TexasRover

Member Since: 24 Nov 2022
Location: Paris
Posts: 1040

2002 Defender 110 Td5 DCPU Chawton White

Td5 Anti Stall - not working right?

Hi All,

Where I live now my drive is a steep hill which pretty much starts from the garage door. I forever have to go to low range (keeps that lubricated!) because whatever I do I will stall the engine in hi range.

I had a Td5 Discovery (99 10P) manual - fantastic car and never recall having stalling issues. I know the Td5 has an antistall build in which I assume has something to do with fueling. Could there be an issues with that on my car?

Now my clutch biting point is very low, but the ECU gets the clutch signal (checked with nanocom). I was thinking maybe the antistall uses the clutch signal and possibly this is out of sync? I tried to adjust my clutch, bleed it etc, no luck. Someone has been in there (bought the car in Oman..) and it is a right mess in there. I was going to remove the whole pedal, refurbish and properly adjust. I actually have a whole spare assembly in my parts stash..

27th Feb 2023 12:27pm

thinman21

Member Since: 27 Jan 2020
Location: Nottingham
Posts: 11

The TD5 anti-stall is a bit rudimentary:

To use it going up a steep hill: stop at the bottom, select 4WD low range, select 1st gear (all with clutch in) Turn off your ignition, wait for a few seconds, release the clutch pedal, then turn the ignition on (without the clutch in, and don't touch the accelerator or brakes) your truck should climb the steep hill, even lose terrain/hill without any driver input other than steering.

Are you using it like that (I have to read my notes every-time I need it as I forge......

27th Feb 2023 1:22pm

TexasRover

Member Since: 24 Nov 2022
Location: Paris
Posts: 1040

Ah no, i don't drive out my garage in first low hitting the starter without clutch. It's steep but not that steep. Low range works just fine, I must be the only person in France using low range daily!

Ok in that case never mind.. i will still fix the clutch but won't expect any miracles. Soon enought we will move to a purchase house hopefully with a normal drive ( and room for some more Landrovers..)

Thanks.

27th Feb 2023 2:33pm

4RF RDS

Member Since: 19 Jul 2015
Location: Ottawa
Posts: 930

2000 Defender 110 Td5 XS CSW Epsom Green

If it has been messed about is the wiring and plug still attached to the master cylinder? If so and you have a signal (Nanocom confirmed you said) just let the clutch out slowly and do not touch the accelerator. Once moving give it throttle. That is how the anti-stall works in high range.

Good luck.

Click image to enlarge 2010 Range Rover MkIII Autobiography Super Charged (Idris)
2003 Range Rover Mk III (Desmond FitzWilliam)
2000 Defender 110 CSW TD5 (CTX)
1992 Range Rover Classic (Lizzy)
1972 Series III 300 Tdi (Stanwood)
1967 MGB GT

Every normal man must be tempted at times to spit on his hands, hoist the black flag, and begin to slit throats.
H. L. Mencken (1880 - 1956)

27th Feb 2023 3:04pm

blackwolf

Member Since: 03 Nov 2009
Location: South West England
Posts: 17359

2007 Defender 110 Puma 2.4 DCPU Stornoway Grey

thinman21 wrote:
The TD5 anti-stall is a bit rudimentary:

To use it going up a steep hill: stop at the bottom, select 4WD low range, select 1st gear (all with clutch in) Turn off your ignition, wait for a few seconds, release the clutch pedal, then turn the ignition on (without the clutch in, and don't touch the accelerator or brakes) your truck should climb the steep hill, even lose terrain/hill without any driver input other than steering.

Are you using it like that (I have to read my notes every-time I need it as I forge......

Your "ins" and "outs" are confused. A clutch is "in" when the pedal is released and "out" when the pedal is pressed. It has been this way since motors where invented and not even the Internet can change it.

27th Feb 2023 6:21pm

landy andy

Member Since: 15 Feb 2009
Location: Ware, Herts
Posts: 5682

2006 Defender 110 Td5 USW Zermatt Silver

Is your MAF ok?

A poorly MAF makes a Td5 very flat at low revs. Just a thought.

27th Feb 2023 6:26pm

blackwolf

Member Since: 03 Nov 2009
Location: South West England
Posts: 17359

I bought my Td5 Disco new and for years never even realised it had anti-stall, it's that good.

My 2.4 Puma is a completely different story, the a/s is extraordinary.

It may well be there's nothing wrong with yours.

27th Feb 2023 6:54pm

kenzle8a

Member Since: 12 Feb 2020
Location: None
Posts: 1074

My antistall got a bit funny at about 153k miles when the clutch and DMF were failing. It was very fussy setting off up anything steep in 1st at that point. Once my new LOF clutch and SMF went in its been fine for the last 15k miles, it will even pull off without stalling with our 3 tonne horse trailer on the back, even up the slight hill into the farm.

27th Feb 2023 7:57pm

blackwolf

Member Since: 03 Nov 2009
Location: South West England
Posts: 17359

Perhaps it works better on the Defender TD5 than the Disco TD5 in that case!

27th Feb 2023 8:08pm

kenzle8a

Member Since: 12 Feb 2020
Location: None
Posts: 1074

its pretty good on mine, I've only really driven a brand new TD5 or a very old TD5 that ive replaced a lot of bits on so I've never had one over a long period of time.

Since I rebuilt the fuel pressure regulator and did the clutch and flywheel and the PCV valve and injector harness and cleaned the ECU when I got it unsurprisingly drives a lot better than when I picked it up.

Mine isn't mapped and still has the EGR in place.

27th Feb 2023 8:14pm

TexasRover

Member Since: 24 Nov 2022
Location: Paris
Posts: 1040

Thanks all for your feedback. I have a nanocom and have chased every failed components (such as MAF). Also had leaking intake and exhaust gaskets, even had to skim the exhaust manifold etc. It used to smoke on acceleration, which now it does not. Turbo pressure seems good.

I will keep looking and will start with getting the clutch improved..

27th Feb 2023 9:25pm

TexasRover

Member Since: 24 Nov 2022
Location: Paris
Posts: 1040

Oh yeah I bought a new (LR) PCV valve - not yet fitted. And I got hold of a 15p EGR system, which has been removed of course and plan to refit soon. I know the horror, but I like things original and with regular cleaning it can only be beneficial for the environment.

Clutch was recently changed by PO I have the receipt. Must be dual mass as there are no change vibrations.

27th Feb 2023 9:30pm

Chicken Drumstick

Member Since: 17 Aug 2020
Location: Near MK
Posts: 716

Re: Td5 Anti Stall - not working right?

TexasRover wrote:
Hi All,

Where I live now my drive is a steep hill which pretty much starts from the garage door. I forever have to go to low range (keeps that lubricated!) because whatever I do I will stall the engine in hi range.

I had a Td5 Discovery (99 10P) manual - fantastic car and never recall having stalling issues. I know the Td5 has an antistall build in which I assume has something to do with fueling. Could there be an issues with that on my car?

Now my clutch biting point is very low, but the ECU gets the clutch signal (checked with nanocom). I was thinking maybe the antistall uses the clutch signal and possibly this is out of sync? I tried to adjust my clutch, bleed it etc, no luck. Someone has been in there (bought the car in Oman..) and it is a right mess in there. I was going to remove the whole pedal, refurbish and properly adjust. I actually have a whole spare assembly in my parts stash..

I know when I've driven Td5 Discos in high range, they have been easy to stall when moving them about in a yard. I found if you had any pressure on the throttle pedal (resting your foot) or just a light throttle they will stall easily. If you put you right foot on the floor and completely off of the pedal then it was mostly impossible to stall them doing the same moving about.

2nd Mar 2023 3:34pm

phillips321

Member Since: 16 Dec 2021
Location: UK
Posts: 103

2005 Defender 110 2.5 TD DCPU Belize Green

Anti stall turns off if you touch the clutch or accelerator. I literally have to trust the car and take feet off everything and let it go.

3rd Mar 2023 10:14pm

roel

Member Since: 08 Aug 2009
Location: Lelystad
Posts: 2039

Anti stall works, just get your feet off the pedals and as long as there are not sudden drops and climbs it works good.

http://youtu.be/qQrDcALvG0Q

Yes this was about 10 years ago. Roel

1984 90 2.5 na Diesel - RR V8 (1994-2001)
1997 Camel Trophy Discovery 300TDI (2001-2009)
2005 G4 Discovery III 4.4 V8 (2008-2018) It's gone but it still hurts.
2003 90 Td5 (2009-now)

13th Mar 2023 8:52pm

Page 1 of 1

All times are GMT

Jump to

< Previous Topic | Next Topic >

Posting Rules

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum