DEFENDER2.NET - View topic - P2263-22 ERROR ON 2.2 PUMA

↓ Advertise on Defender2 ↓

Home · FAQ · New Posts · My Posts · PMs · Search · Members · Map · Calendar · Profile · Donate · Register · Log In

Home > Puma (Tdci) > P2263-22 ERROR ON 2.2 PUMA

Page 1 of 1

Print this entire topic ·

philrally74

Member Since: 20 Jun 2016
Location: STQFFORD
Posts: 1

2012 Defender 90 Puma 2.2 SW Santorini Black

P2263-22 ERROR ON 2.2 PUMA

Hi Guys

I am looking for a little advise if possible - my 2012 2.2 puma has gone into limp mode - it happened after I was towing a trailer with 3t on - the fault icoming up is P2263-22 which is a turbo / air pressure issue etc - I have looked for a cracked/ holed pipe etc nothing - I have run it and the turbo spools up no probs - is there anything glaring that I am missing?

It has previously blown a whopping hole in the intercooler pipe which has been replaced since which time I have had no issues!

Any help would be welcomed

Thanks in advance phil

20th Jun 2016 2:08pm

hornet

Member Since: 04 Jan 2010
Location: Western Europe
Posts: 361

The first things I would do:

Check electrical wiring, especially the wires at the plug/cable lugs. There are known issues!
Check actuating motor/leverage at different rpm
Check/clean/replace Mass-flow-sensor

21st Jun 2016 1:22pm

Puma22

Member Since: 22 Jun 2022
Location: North Yorkshire
Posts: 29

Re: P2263-22 ERROR ON 2.2 PUMA

philrally74 wrote:
Hi Guys

I am looking for a little advise if possible - my 2012 2.2 puma has gone into limp mode - it happened after I was towing a trailer with 3t on - the fault icoming up is P2263-22 which is a turbo / air pressure issue etc - I have looked for a cracked/ holed pipe etc nothing - I have run it and the turbo spools up no probs - is there anything glaring that I am missing?

It has previously blown a whopping hole in the intercooler pipe which has been replaced since which time I have had no issues!

Any help would be welcomed

Thanks in advance phil

I know this is old now, but did you find a solution?

3rd Sep 2022 6:33pm

Doc P

Member Since: 03 Apr 2016
Location: Midlands
Posts: 565

2013 Defender 110 Puma 2.2 XS CSW Firenze Red

Mine needed a new turbo in the end. Recurrent limp mode/MIL light on and a squeal under load from the front of the engine on and off. Fuel consumption more woeful than usual. Same error code. £1500🙄

22nd Sep 2022 11:12am

Ianh

Member Since: 17 Sep 2018
Location: Essex
Posts: 1972

See. This from BAS https://bellautoservices.co.uk/p2263/.

First check clips and pipes.

Airbox to turbo.

Turbo to intercooler- note can hole on underside from rubbing on steering column and on side near alternator bolt, however this should have been rectified with brackets fitted on 2.2’s.

Intercooler to inlet manifold, 3 pipes, first rubber, then metal, then a short 90 degree rubber elbow to the inlet manifold. This last pipe can hole on the underside, it’s hard to see and feel and you can get a view from under the vehicle.

Check intercooler for splits at seams, especially on offside at bottom (left side if standing in front of vehicle looking at engine) as they do split, some soot may be there as an indicator.

Next It’s checking the maf, Map and Air Charge Temperature Sensors and wiring. https://www.defender2.net/forum/topic69503.html?highlight=charge

Then it’s turbo actuator, https://www.defender2.net/forum/topic60413.html?start=540

22nd Sep 2022 12:01pm

Page 1 of 1

All times are GMT

Jump to

< Previous Topic | Next Topic >

Posting Rules

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum