↓ Advertise on Defender2 ↓

Home > Puma (Tdci) > DSC Warning Light Permanently on following Dbl DIN Coversion
Post Reply  Down to end
Page 1 of 1
Print this entire topic · 
Albarker55



Member Since: 02 May 2022
Location: Fleet, Hants
Posts: 22
2015 Defender 110 Puma 2.2 XS CSW Santorini Black
DSC Warning Light Permanently on following Dbl DIN Coversion
I seek some help from the experts out there please as I am a relative newby to the Defender. I have just completed a double din conversion, fitting an Alpine ilx-705d and have a problem with the DSC warning light being permanently on when I turn the ignition on. Here is what I did with the refit:

Extended the DSC Off switch loom to reposition switch
Removed the steering wheel (like a numbty I did not note the position of the sensor)
Spliced in the speed sensor cable from the HU to cable 13 on instrument panel loom

Operation of the DSC off switch does not seem to have any effect.

How can I extinguish the warning light? I have tried moving the steering wheel position sensor and his has no effect!

Grateful for some guidance please


Update 8 Nov:

Purchased a GAP IID tool and ran the diagnostics and then cleared all faults. Warning light has gone away and the steering wheel position sensor has been correctly calibrated. Job done!
Post #970264 7th Nov 2022 1:22pm
View user's profile Send private message View poster's gallery Post Reply
Post Reply  Back to top
Page 1 of 1
All times are GMT

Jump to  
<  Previous Topic | Next Topic >
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



Site Copyright © 2006-2024 Futuranet Ltd & Martin Lewis
DEFENDER2.NET RSS Feed - All Forums