Member Since: 06 Sep 2020
Location: In the wild
Posts: 101
TD5 Hone or Rebore
So the manuals say not to rebore a TD5. Although I know turners have no problems with it and sell oversized pistons for this. However, would this get away with honing or would it need a rebore. Number one is the worse with a little bit of scuffing. The others are all pretty good except 5 just at the top.
Click image to enlarge
Click image to enlarge
Click image to enlarge
Click image to enlarge
12th Mar 2021 5:47pm
landy andy
Member Since: 15 Feb 2009
Location: Ware, Herts
Posts: 5790
As you say a hone would work on most cylinders but one of them looks bad. Can’t really tell by a photo if it’s too scored to require more than a hone. I assume you would hone yourself, and take to engineering shop for bore. So either hav3 a go honing the worst, or take the bloke to an engine shop and get an opinion.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
12th Mar 2021 9:02pm
