↓ Advertise on Defender2 ↓

Home > Puma (Tdci) > Anyone have list of problems that cause limp mode?
Post Reply  Down to end
Page 1 of 1
Print this entire topic · 
Mogboy



Member Since: 21 May 2013
Location: Brisbane
Posts: 31

Australia 2007 Defender 110 Puma 2.4 SW Belize Green
Anyone have list of problems that cause limp mode?
Hi

My 2007 Puma has gone into limp home 3 times in 7 months, otherwise it runs faultlessly. On each occasion slight increase in accelerator from 80 kph initiated limp mode. There are no fault codes, not running hot, and each time switch off and re-start and back to perfect operation with full power.

A list of factors setting off limp mode might help me. Or maybe someone has suggestions please?

Cheers
Mogboy
Post #630663 12th Jun 2017 5:38am
View user's profile Send private message View poster's gallery Reply with quote
zsd-puma



Member Since: 09 Aug 2016
Location: Kent
Posts: 2720

United Kingdom 2010 Defender 110 Puma 2.4 USW Santorini Black
Sudden loss of coolant used to do it on Transits, you should get some kind of fault code if the ECU is putting it into Limp mode.

What you probably have is something failing which is causing a loss of power rather than the ECU detecting a fault and giving you restricted performance.

Volume Control valve on the fuel pump could do it an EGR that's mechanically failed could also do it i think.
Post #630788 12th Jun 2017 3:45pm
View user's profile Send private message View poster's gallery Reply with quote
clifflandy



Member Since: 13 Mar 2014
Location: Lichfield
Posts: 109

United Kingdom 2007 Defender 90 Puma 2.4 HT Zambezi Silver
Re: Anyone have list of problems that cause limp mode?
Mogboy wrote:
Hi

My 2007 Puma has gone into limp home 3 times in 7 months, otherwise it runs faultlessly. On each occasion slight increase in accelerator from 80 kph initiated limp mode. There are no fault codes, not running hot, and each time switch off and re-start and back to perfect operation with full power.

A list of factors setting off limp mode might help me. Or maybe someone has suggestions please?

Cheers
Mogboy


Did you get a diagnosis and fix your issue Mogboy? My 07 2.4 has the same problem. It happens about once every 6 weeks and at all other times runs faultlessly.
Post #728002 8th Sep 2018 9:53pm
View user's profile Send private message View poster's gallery Reply with quote
custom90



Member Since: 21 Jan 2010
Location: South West, England.
Posts: 20340

United Kingdom 
Clean MAP and MAF sensors, this isn't a cure all solution but they won't always throw up and codes if very dirty.
The MAF especially can cause a lot of issues!
If it doesn't solve it, it won't do any harm.

Thumbs Up $W33T $0U7H3RN $UG4R
🇬🇧🏴󠁧󠁢󠁥󠁮󠁧󠁿🏴󠁧󠁢󠁷󠁬󠁳󠁿🏴󠁧󠁢󠁳󠁣󠁴󠁿🇮🇪🇺🇸⛽️🛢️⚙️🧰💪
Post #728003 8th Sep 2018 10:46pm
View user's profile Send private message View poster's gallery Reply with quote
clifflandy



Member Since: 13 Mar 2014
Location: Lichfield
Posts: 109

United Kingdom 2007 Defender 90 Puma 2.4 HT Zambezi Silver
Thanks for the advice. MAP and MAF sensors cleaned. Out for a test drive tomorrow. Thumbs Up
Post #728502 11th Sep 2018 3:30pm
View user's profile Send private message View poster's gallery Reply with quote
Grenadier



Member Since: 23 Jul 2014
Location: The foot of Mont Blanc...
Posts: 5804

France 2011 Defender 110 Puma 2.4 DCPU Corris Grey
Re: Anyone have list of problems that cause limp mode?
Mogboy wrote:
Anyone have list of problems that cause limp mode?


We are taking Defenders here, right Whistle

Just last week I went through the full list of recommendations mentioned above, as I had a series of limp moments, only to find it was (very) low on coolant. Note it was NOT showing on the dash temp guage. Certainly give that a check, as it stopped as soon as I had refilled to the correct amount. Monsieur Le Grenadier

I've not been everywhere, but it's on my list.....

2011 Puma 110DC - Corris Grey
Post #728503 11th Sep 2018 3:35pm
View user's profile Send private message View poster's gallery Reply with quote
ericvv



Member Since: 02 Jun 2011
Location: Near the Jet d'Eau
Posts: 5816

Switzerland 2009 Defender 110 Puma 2.4 SVX Station Wagon Santorini Black
Limp mode with yellow check engine light happened a few times to me when truck was still very new. Restarting usually solved it temporarily. Proved to be a faulty functioning EGR valve, once dealer replaced that problem gone.
Eric You never actually own a Defender. You merely look after it for the next generation.
http://youtu.be/yVRlSsJwD0o
https://youtu.be/vmPr3oTHndg
https://www.youtube.com/watch?v=_GtzTT9Pdl0
https://www.youtube.com/watch?v=ABqKPz28e6A
https://www.youtube.com/watch?v=rLZ49Jce_n0
https://www.youtube.com/watch?v=XvAsz_ilQYU
https://www.youtube.com/watch?v=K8tMHiX9lSw
https://m.youtube.com/watch?v=dxwjPuHIV7I
https://vimeo.com/201482507
https://www.youtube.com/watch?v=ZSixqL0iyHw
Post #728505 11th Sep 2018 4:17pm
View user's profile Send private message View poster's gallery Reply with quote
Orangesofa



Member Since: 10 Oct 2014
Location: Somerset
Posts: 214

United Kingdom 2013 Defender 90 Puma 2.2 SW Keswick Green
My wife was towing a horse in a horse box and the defender went bang and reverted to limp mode. After a call to me and her visual inspection (reporting nothing obvious) she continued about a mile to her destination. I drove over to meet her and investigate to find a tell tale dribble of oil on the floor and the intercooler hose a good 2 inches off the intercooler. She hadn't noticed this and thankfully a simply fix to get her home without limping... Phil
Post #728620 12th Sep 2018 2:27pm
View user's profile Send private message View poster's gallery Post Reply
Post Reply  Back to top
Page 1 of 1
All times are GMT

Jump to  
Previous Topic | Next Topic >
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



Site Copyright © 2006-2024 Futuranet Ltd & Martin Lewis
DEFENDER2.NET RSS Feed - All Forums