↓ Advertise on Defender2 ↓

Home > Td5 > Removing rear drive shafts
Post Reply  Down to end
Page 1 of 1
Print this entire topic · 
excossack



Member Since: 22 Feb 2012
Location: North West
Posts: 5850
United Kingdom 1999 Defender 110 Td5 SW Caledonian Blue
Removing rear drive shafts
To remove the rear drive shafts on a 110;

Slacken off wheel nuts, jack up and support axle.
Remove wheel & centre rubber cap (if fitted)
Undo drive flange bolts
Withdraw the shaft?
Refitting - being the reverse of the above?

Seems quite simple....What about bearings and oil seals? Will the shaft withdraw without the need to remove wheel bearings & seal ? 1999 Defender TD5 110

Regards
John M0VAZ
Econet Station 48 no clock
Post #667875 30th Nov 2017 8:48am
View user's profile Send private message View poster's gallery Reply with quote
rallysteve



Member Since: 10 Feb 2014
Location: Cumbria
Posts: 2237
United Kingdom 2002 Defender 110 Td5 DCPU Keswick Green
I presume you have alloy wheels? if you have steel wheels you dont even have to remove.

No bearings or seals to worry about. There is a gasket on the drive flange but cleaning up the faces and using a decent silicone will be fine for reassembly.

Leave the drive flange on the halfshaft for removal too.

Steve 02' 110 TD5 Double Cab Rebuild Thread
Post #667876 30th Nov 2017 8:53am
View user's profile Send private message View poster's gallery Reply with quote
excossack



Member Since: 22 Feb 2012
Location: North West
Posts: 5850
United Kingdom 1999 Defender 110 Td5 SW Caledonian Blue
Cheers Steve.

Yep I have alloy wheels. Seems quite simple TBH. 1999 Defender TD5 110

Regards
John M0VAZ
Econet Station 48 no clock
Post #667883 30th Nov 2017 9:29am
View user's profile Send private message View poster's gallery Reply with quote
rallysteve



Member Since: 10 Feb 2014
Location: Cumbria
Posts: 2237
United Kingdom 2002 Defender 110 Td5 DCPU Keswick Green
Yeah, just go easy with the drive flange bolt removal as they can be known to snap if they have previously been overtightened/threads full of silicone.

Its worth having a bit of rag to hold around the shaft as you pull it out as it will likely be coated in axle oil.

I generally like to drain the diff oil before removing the shafts as i can overflow through the end of the stub axle if it is too full or you are parked on a side slope.

Steve 02' 110 TD5 Double Cab Rebuild Thread
Post #667888 30th Nov 2017 10:09am
View user's profile Send private message View poster's gallery Post Reply
Post Reply  Back to top
Page 1 of 1
All times are GMT

Jump to  
<  Previous Topic | Next Topic >
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



Site Copyright © 2006-2024 Futuranet Ltd & Martin Lewis
DEFENDER2.NET RSS Feed - All Forums