↓ Advertise on Defender2 ↓

Home > Puma (Tdci) > Coolant level alarm.
Post Reply  Down to end
Page 1 of 1
Print this entire topic · 
andy63



Member Since: 30 Jun 2023
Location: north east
Posts: 515
United Kingdom 
Coolant level alarm.
After a recent near miss where I'd lost a fair bit coolant with a dodgy fitted clip I thought I'd fit an alarm..
Got one that fits into the top hose, and fitting is straight fwd.. The fiddly bit is running the wires..
It a audible wit a visual flashing led as well... Facility to power a relay when it actuated.. I didn't use that..
Its a simple float type on off switch, and has a 20sec delay before alarming..
The highest point on my top hose is close to a 90deg bend and I did wonder if turbulence might be an issue but went ahead and fitted it there..
On the test drive I found out it works🙈🤣
As I'd managed not to tighten a clip..
About 3 miles into the drive it alarmed, and after a bit swearing and muttering I thankfully pulled in to find coolant all over..
You can see the offending llip in the photo I took of the install🙄😩..


Click image to enlarge
While I had the coolant drained I fitted an alloy expansion tank as well👍


Click image to enlarge
I'll see how it all goes👍
Post #1030026 1st Apr 2024 8:54am
View user's profile Send private message View poster's gallery Reply with quote
geobloke



Member Since: 06 Nov 2012
Location: Nottinghamshire
Posts: 4410
United Kingdom 
Love the expansion tank and red hoses. Very smart.

What are those hose buffers you you have fitted. Like those too... Thumbs Up
Post #1030032 1st Apr 2024 9:52am
View user's profile Send private message View poster's gallery Reply with quote
andy63



Member Since: 30 Jun 2023
Location: north east
Posts: 515
United Kingdom 
Hi G... The buffers are standard fit on the hoses as far as I know... Certainly wasn't me who put them on but they prevent the hoses rubbing were there is contact, and it's tight down that side with a right nest if hoses😩
The one fitted to the top hose where I put the sensor was the reason for me little mishap.. I had actually installed it well enough but realised I'd left the rubber buffer off so undid that clip and fitted the buffer... But forgot to tighten the clip again😩
Post #1030034 1st Apr 2024 10:02am
View user's profile Send private message View poster's gallery Post Reply
Post Reply  Back to top
Page 1 of 1
All times are GMT

Jump to  
<  Previous Topic | Next Topic >
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



Site Copyright © 2006-2024 Futuranet Ltd & Martin Lewis
DEFENDER2.NET RSS Feed - All Forums